Induction technology means that the bearing does not have to touch the crossbars for heating to occur. Easy to use; you can mount a bearing in minutes. Eliminates hammering and pounding to cold-mount bearings to extend bearing life and cuts operating costs. Works on bearings, sprockets, gears, couplings, sleeves for versatility and increased productivity. No more open flames, torches or open oil baths for heating, reducing risk to the operator. Also demagnetizes bearings – simply remove bar, turn heater on and pass bearing several times between the two upright columns without contacting them.
Questions on Bessey SC 110V Reco Induction Bearing Heater 11-Inch O.D. x 4-3/8-Inch W, 110 Volt
- From Scott at 10/21/10 6:16 AM
- Does this unit have an automatic temp shut off or can it be preset. Also, is there a ready indicator light? If not, what setups have been used in this application to control the max temp rates.
- The Bessey SC 110V Reco Induction Bearing Heater does not have a temperature shut off or preset function, basically it will heat as long as you leave your bearing in place and would be tested for temperature with a probe or infrared thermometer.
The SC110D Digital Induction Bearing Heater has a bearing capacity of 4-3/8-inch x 11-inch O.D. and up to 14-inch O.D. with optional raising blocks, has a computer chip that monitors and stabilizes temperature and uses a display panel to allow the user to pre-set times, temperatures and auto shut off. The SC110D may be more of what you are looking for. You can see the SC110D by jumping here - http://www.toolking.com/bessey-reco-induction-bearing-heater-sc-110d-110-volt-17-a
- From Ganesh Boodram at 4/6/10 8:54 AM
- What is the smallest size and the largest size of bearing it can heat and the weight of this unit?
- The Bessey SC 110V Reco Induction Bearing Heater 11-Inch O.D. x 4-3/8-Inch W, 110 Volt can heat bearings up to 4-3/8-inch wide x 11-inch outside diameter and you can go up to 14-inch outside diameter with the optional raising blocks. The smallest bearing you can put on will have to have a center of 3/4-inch or larger. The SC110V weighs about 60 pounds.